| About ROSAT |
ROSAT Home Page | ROSAT Images |
|---|
The time variability of X-ray emission can be studied with the HRI since
each detected photon has its time of arrival recorded by the detector.
The accuracy of this time is limited by the electronic resolution
of the HRI processor which is 61 
sec relative to the
ROSAT spacecraft clock.
The relative arrival times of photons during a single observation
is accurate to this value.
The absolute accuracy of the ROSAT spacecraft clock,
and its conversion to UT, is expected to be a few milliseconds.
The HRI has a processing dead time during which events may not be
counted which varies between 0.36 and 1.35 msec per event.
The variation is discussed in section 4.3.2.5 and depends
on the fine position of the event.
Thus there is a dead time correction that needs to be made for
calculating the true event rate from a source.
A mean dead time of 
= 0.81 msec can be used for this purpose,
and the true rate is then given by: 
,
where n is the observed rate.
Due to the telescope wobble and the small variations in the QE of the HRI on spatial scales of a few arc minutes (see Fig. 5.13), the count rate of a source can vary by 5% between the extremities of a wobble. This can produce a low amplitude source variability on a time scale of approximately 100-400 seconds in some sources.
As for the PSPC, the HRI observations are typically interrupted once per orbit, and sometimes as much a three times per orbit. Typical continuous viewing times for a source will be about 2000 seconds, with some cases lasting up to 4000 seconds. Long term monitoring of sources on time scales of weeks of more will be limited by the solar view constraints of the satellite. This limits source accessibility to about one month every six months for a source in the elliptic plane, with greater access time for sources closer to the ecliptic poles.