Target Name: 			
	Target name *MUST* be same as that in ASM Catalog

SSC Selection:			SSC#0    SSC#1    SSC#2
        Select SSC to be used
Binning
Bin Width:		  	 (Day)
	Bin width can be selected only with QDP Mode or ROBOT Mode.
	To output data without binning, specify 0.0 as the bin width.
	The average is weighted by the uncertainty of each data.
	If the source variation is large, RMS of source count rate may
	give better estimate of the uncertainty of the count rate.

Time Period
MJD:			  From:   To: 
MET:			  From:   To: 
	Time period can be specifyed both in MJD and MET.   Default
	values yield all data, but requires longer time, which may
	cause timeout error.  We strongly recommend specifying the 
	time region especially for bright persistent sources.

Data Selection Criteria
Maximum Reduced chi-sqare:	
	According to MIT, 1.5 is a good criterion.   For scox1 (Sco X-1), MIT uses 8.0, instead.  

Detection Level:		
	Detection level in sigma (select data with count rate >= sigma x error) 

Minimum Count Rate:		
	Specify minimum count rate to output.   Negative value is acceptable.

Minimum Transimission:		

Field of View of the Counter:
		     Theta: Min   Max 
		      Phi:  Min   Max 
	MIT pepole recommends -46.0 <= theta <= 46.0 AND -5.0 <= phi <= 5.0.
	They also recommend not to use the data with theta < -41.5 for low-state trigger. 
	These values are used in monitoring of possible TOOs triggered by ASM in XTE SOF.

Source Contamination:
	   Minimun Delta-Theta:   Minimum Delta-Phi: 
	Fundamentally, if there is another source within delta-theta < 6.0 degree AND delta-phi < 0.05 degree,
	we assume the detection as "BAD" in XTE SOF.   If there is another source within delta-theta < 10.0 
	degree AND delta-phi < 0.2 degree, we assume it as "IFFY".   Detailed information will be available
	on Web soon.

Output Mode: 			
 		Detailed Mode
 	QDP Mode
 		Robot Mode

	Detailed Mode: output 13 column
	QDP MODE: output in format directly plotable with qdp 
	Robot MODE: output in format directly plotable with Robot